What are the conditions of use of automatic cnc lathe machine
The normal use of automatic cnc lathe machine generally needs to meet the following conditions, the power supply voltage fluctuation at the machine tool location is small, the ambient temperature needs to be less than 30 degrees, and the relative temperature is less than 80%.
Environmental requirements require that the position of the machine tool should be far away from the vibration source, need to avoid the effects of direct sunlight and heat radiation, and avoid the effects of humidity and airflow. For example, if there is a vibration source near the machine tool, anti-vibration grooves should be set around the machine tool. Otherwise, it will directly affect the machining accuracy and stability of the machine tool, and will cause poor contact of electronic components, malfunction, and affect the reliability of the machine tool.
Power requirements. Generally, automatic cnc lathe machine is installed in the machining workshop. Not only because the ambient temperature changes greatly and the use conditions are poor, but also because there are many kinds of electromechanical equipment, this will cause large fluctuations in the power grid. Therefore, the location where the automatic cnc lathe machine is installed requires strict control of the power supply voltage. The power supply voltage fluctuation must be within the allowable range and remain relatively stable. Otherwise it will affect the normal operation of the CNC system.
Temperature conditions, the ambient temperature of the general automatic cnc lathe machine will be lower than 30 degrees, and the relative temperature is less than 80%. Therefore, there is an exhaust fan or a cooler inside the CNC electric control box to maintain the electronic components, especially the working temperature of the central processor is constant or the temperature difference changes little. Excessively high temperature and humidity will reduce the life of control system components and lead to increased failures. Increased temperature and humidity, increased dust will cause adhesion on the integrated circuit board, and cause short circuits.
Standardize the use of machine tools
When using the machine tool, the user cannot arbitrarily change the parameters set by the manufacturer in the control system. The setting of these parameters will affect the dynamic characteristics of each part of the machine tool. Only the value of the gap compensation parameter can be adjusted according to the actual situation.
The user cannot replace the machine tool accessories at will, such as using a hydraulic chuck that exceeds the specifications. The manufacturer fully considers the matching of various link parameters when setting up accessories. Blind replacement causes mismatches in various link parameters and may cause serious accidents.